Safer Operation and Faster Movement
Unique-low-center-of-gravity design helps higher stability of the forklift:
After a thoroughly investigation of vehicle structure, Sinkobe decided to use a low-center-of-gravity design. The forklift has the smallest turning radius in its class (1.760 mm/1.5 tons) and offers stability under any load condition.

High-speed travel and acceleration enable faster load handling:
The forklift's motors for traveling and load handling feature the highest traveling speed ( 15 km/h) and loading speed in its class.
 Since motor acceleration has been improved, frequent switchback operations can be done easily to significantly enhance work efficiency.

Forced loading is easily done, supported by impressive gradeability:
Gradeability has been increased by one seventh (with load) so that the forklift can climb a sharp slope and accmmodate the difference in level easily and safely. Moreover , the forklift's powerful forced loading capacity allow load to be easily stacked.
Battery Charging is Easier and More Accurate

A microcomputer-controlled automatic tap changeover function facilitates proper charging.
The latest fully automatic charging system is employed. Should power voltage fluctuate while charging, the microcomputer detects it and changes the tap over automatically to prevent overcharging or undercharging. Automatic, quick charging system reduces charging time.
Should the battery lose up 50% of its charge. quick charging is done automatically to increase charging by 20% . This function allows load handling work to continue under the most sevare work conditions.

Battery charge reservation enables full operation at the start of the next working day.

The battery charging can be preset for next week's operation. Setting the timer (up to 99 hours) at the end of the work week prevents operating loss due to low battery solution temperature, so start operations for the next workday can be begin without fail.
Note: Only applicable to buill-in charger.

Quieter Operation in Consideration of the Environment


Noise caused by traveling and handling load is reduced.
Because the hydraulic pump operates at the speed necessary for a particular job, the intermittent sound volume is reduced to 66 dB. The travel and drive gears are specially engineered to achieve a low noise level of 68 dB, so the forklift is not only comfortable for the operator but for those in the area as well.

Back buzzer with selectable sound level at the job site.
The sound volume of the new back buzzer can be set to Hi, Lo or Off. The appropriatesound volume can be selected according to the work environment.

 
JAPAN SINKOBE CO., LTD.  
Office : No.11~8~1202, 3~Chome, Minato, Chuo~Ku
  TEL : (03)-5542-7388(REP.) FAX : (03)-5542-7389
WebSite : www.sinkobe.com
E-Mai l: sales@sinkobe.com
copyright © all right reserved